SKR1.3, TMC2209 and BLTOUCH with direct Drive

The SKR1.3 board is a cheap entry-level 32 bit board for 3d printing enthusiasts and has the added benefit of being able to run TMC drivers without additional wiring. For this project, I am using the TMC2209 Drivers and will be running the, in UART mode. I will not be using the sensorless homing feature, as at the time of writing this is a little buggy in Marlin 2.0.x

Ender 3 Pro – Upgrades

One of the best things about the Creality Ender 3 Pro is the ability to mod it and add to it, there are many upgrades that can be done to improve prints, quieten down the printer, and make it easier to use. I’m going to go through some of these in this post and hopefully …

Read moreEnder 3 Pro – Upgrades